She is made out of paper and is 95 cm high (to the top of her hair, her ear is a bit higher), that is 37,5 inches, and so she is bigger then I am when I am sitting.
I will make a 360° gif in the next days, so you can see her from all sides.
It is based on the models of poninnahka.deviantart.com/art/…
whos models are based on the models of
Ok, here is everything you need to build your own:
the .pdo for pepakura dl.dropboxusercontent.com/u/42…
the papers without numbers dl.dropboxusercontent.com/u/42…
the papers with numbers dl.dropboxusercontent.com/u/42…
Attention: this is a not textured model, since the texture maps where broken I did not bother to go though all the work to make them happen
(well I used the colors, that you dont see in my model because b/w print, so all that is missing are her eyes and her cutie mark),
and her right wing was not connected after importing it in pepakura.
If you want to paint the model after folding like me that is no problem at all, you just have to notice that the right wing in inverted as a model (so the colored side is INSIDE the wing).
If you want to have a textured model, maybe you or someone else can work better with textures then me, so here is the 3d model from blender dl.dropboxusercontent.com/u/42…
and a .obj from it dl.dropboxusercontent.com/u/42…
After papercrafting it, did you cover it with primer ? Or immediately painted it? c:
Did you make the Pinkie Pie that was at GalaCon last year? If yes: Will Derpy (or another one) be there this year?
Und ein verwirrendes Foto gemacht. Sieht aus wie ein digitales 3D-Objekt in realer Umgebung.
But I have to dust her off, she has gathered some dust.
I am not going to paint over these moddels so i'd like to know what the problem is.
Thanks a lot.
I hope Derpy would be ok with a little water, since I painted her with acrylic paint, she should withstand at least a bit...
but you are right, she could be easily destroyed in many ways.
still bloddy briliant though
*smashes piggie bank*